Papers on replacement of sand with granite fines

Papers on replacement of sand with granite fines

Nowadays there is a demand for river sand for construction. To avoid these conflicts, we are up to a solution of using sea sand along with granite granules as fine aggregate in concrete. Granite granules are the waste product obtained while cutting granite which is cost effective and sea sand is abundantly available in coastal areas when compared to river sand. This full replacement can be

[email protected]
Send Message Get a Quote
  • Use of Crushed Granite Fine as Replacement to River Sand Use of Crushed Granite Fine as Replacement to River Sand

    Use of Crushed Granite Fine as Replacement to River Sand in Concrete Production . Manasseh JOEL . Civil Engineering Department Universtiy of Agriculture P.M.B.2373, Makurdi, Benue State, Nigeria.. E-mail: [email protected] Received: 30 April 2009 / Accepted: 10 December 2010 / Published: 24 December 2010

  • Geo Polymer Concrete with the Replacement of Granite Geo Polymer Concrete with the Replacement of Granite

    granite fines content was the optimum value for improved structural performance. Kanmalai Williams C et al (2008) examined the performance of concrete made with the granite powder as fine aggregate. Sand was replaced with granite powder in steps of 0, 25, 50, 75 and 100% and cement was replaced with 7.5%Silica fume, 10% fly ash and 10% slag

  • Research Paper EXPERIMENTAL INVESTIGATION ON Research Paper EXPERIMENTAL INVESTIGATION ON

    Concrete is prepared with granite fines as a replacement of fine aggregate in 5 different proportions namely 5%, 15%, 25%, ... paper is on use of granite fines as an alternative to expensive and depleting sand. The world wide ... fully sand as fine aggregates. 3

  • Strength and Durability Properties of Granite Powder Concrete Strength and Durability Properties of Granite Powder Concrete

    The main parameter investigated in this study is M30 grade concrete with replacement of sand by granite powder by 0, 25 and 50% and cement was partial replacement with silica fume, fly ash, slag and super plasticizer. This paper presents a detailed experimental study on compressive strength, split tensile strength 28, 56 and 90 days

  • Study on the partial replacement of fine aggregate Study on the partial replacement of fine aggregate

    The fig 2 shows the variation of slump with different percentage replacement of fine aggregate using induction furnace slag. It was found that the value of slump increases with the incremental percentage of induction furnace slag till 40 percent replacement of fine aggregate and beyond that the slump value goes on decreasing

  • Strength Properties of Concrete with Partial Strength Properties of Concrete with Partial

    The type of fine aggregate used is manufactured sand from granite rock. Sieve analysis of M sand is carried out as per IS:2386 ( Part I ) and it is conformed to grade for Zone II. M sand was having a water content of 0.80% and water absorption of 1.20 %. Sieve analysis of fine aggregate (bottom ash) is

  • STUDY ON PERFORMANCE OF MANUFACTURED SAND STUDY ON PERFORMANCE OF MANUFACTURED SAND

    STUDY ON PERFORMANCE OF MANUFACTURED SAND AS FINE AGGREGATES IN HIGH STRENGTH CONCRETE CONSTRUCTIONS S.S.Saravanan#1, Dr.P.Jagadeesh2 #1 Research scholar, School of Civil & Chemical Engineering, VIT University, India 1 [email protected] 2 Professor, School of Civil & Chemical Engineering, VIT University, India 2 [email protected]

  • Study on Compressive Strength of Quarry Dust as Fine Study on Compressive Strength of Quarry Dust as Fine

    Jul 28, 2016 The concept of replacement of natural fine aggregate by quarry dust which is highlighted in the study could boost the consumption of quarry dust generated from quarries. By replacement of quarry dust, the requirement of land fill area can be reduced and can also solve the problem of natural sand scarcity. The availability of sand at low cost as a fine aggregate in concrete is not suitable and

  • [PDF] Utilization of Waste Marble Dust and Granite Dust [PDF] Utilization of Waste Marble Dust and Granite Dust

    Abstract— The basic objective of this research was to identify alternative source of good quality aggregates. Marble and Granite are important materials used in construction industry. Marble dust is produced from processing plants during sawing and polishing of marble blocks and about 20-25% processed marble is turned into powered form. Granite dust is the stone waste generated from

  • Granite powder concrete | Request PDF Granite powder concrete | Request PDF

    The percentage of granite powder added by weight was 0, 25, 50, 75 and 100 as a replacement of sand used in concrete and cement was replaced with 7.5% silica fume, 10% fly ash, 10% slag and 1%

  • Experimental Study of Partial Replacement of Fine Experimental Study of Partial Replacement of Fine

    [4]. John zachar and Tarun R.naikin [2007] “Replacement of fine aggregate with foundry sand”, Milwaukee journal – sentinel Vol.3, PP.18-22. [5]. Mahmoud solyman [2006] “Classification of Recycled Sands and their Applications as Fine Aggregates for Concrete and Bituminous Mixtures”, journal article: DOI universitat kassel, Vol.5, pp.1-196

  • Characteristics of granite dust concrete with M−sand as Characteristics of granite dust concrete with M−sand as

    Jan 01, 2020 The main aim of this paper is to strengthen the concrete with the fractional replacement of cement by granite dust and replacing the river sand with manufactured sand. The current study is carried out by fractional replacement of cement with granite dust in varying proportions of 0%, 5%, 10%, 15%, and 20% by weight of the cement and fine

  • Experimental study of concrete made with granite and Experimental study of concrete made with granite and

    Sep 01, 2016 For 20% partial replacement of sand with granite powder the increase in the compressive strength was relatively small. The values of compressive strengths of cubes made with different percentages of granite powder replacement of sand are given in Table 5 and also graphically presented in Fig. 4

  • (PDF) Effect of Sand Replacement with Granite Fines on the (PDF) Effect of Sand Replacement with Granite Fines on the

    This paper therefore presents results of an experimental laboratory investigation carried on PKSC by incorporating varying percentages of granite fines to replace sand in steps of 20% to study its

  • Partial Replacement of Sand with Quarry Dust in Concrete Partial Replacement of Sand with Quarry Dust in Concrete

    Granite fines or rock dust is a by-product obtained during crushing of granite rocks and is also called quarry dust. In recent days there were also been many attempts to use Fly Ash, an industrial by product as partial replacement for cement to have higher workability, long term strength and to make the concrete more economically available

  • Partial replacement of sand by granite powder in concrete Partial replacement of sand by granite powder in concrete

    possibility of utilizing the granite powder as partial replacement to sand, an experimental investigation has been carried out. The percentages of granite powder added to replace sand by weight were 0, 5, 10, 15, 20 and 25. This attempt has been done due to the exorbitant hike in the price of fine aggregate and its limited availability

  • Table 2 from Partial Replacement of Sand with Quarry Dust Table 2 from Partial Replacement of Sand with Quarry Dust

    Partial Replacement of Sand with Quarry Dust in Concrete. -The reduction in the sources of natural sand and the requirement for reduction in the cost of concrete production has resulted in the increased need to identify substitute material to sand as fine aggregates

  • AN EXPERIMENTAL INVESTIGATION OF STRENGTH OF AN EXPERIMENTAL INVESTIGATION OF STRENGTH OF

    In this paper an attempt is made experimentally to investigate the Strength Behavior of Concrete with the use of Granite Fines as an additive. Concrete is prepared with granite fines as a replacement of fine aggregate in 5 different proportions namely

  • Study on the partial replacement of fine aggregate using Study on the partial replacement of fine aggregate using

    Research Paper Open Access Study on the partial replacement of fine aggregate using induction furnace slag Ansu John and Elson John ... coarse aggregate such as crushed limestone or granite and fine aggregate such ... replacement of fine aggregate using steel slag was adopted to be 60 percent. Dolomite based concrete mixture

  • Review Paper on Partial Replacement of Fine Aggregate Review Paper on Partial Replacement of Fine Aggregate

    concrete mix with granite powder (GP) and iron powder (IP) as partial replacement of sand showed good workability similar to normal concrete mixes. Using 10% granite powder (GP) in concrete gave the highest increase in compressive strength compared to other ratios. Same results observed for flexural strength. For the split

  • Experimental study of concrete made with granite and iron Experimental study of concrete made with granite and iron

    Sep 01, 2016 The percentages of GP and IP added to replace sand were 5%, 10%, 15%, and 20% of the sand by weight. It was observed that substitution of 10% of sand by weight with granite powder in concrete was the most effective in increasing the compressive and

Latest News

Copyright © 2021.Henan consuol Machinery Co., ltd. All rights reserved. Sitemap

Click avatar to contact us
Click avatar to contact us
gotop